Total Pageviews

Monday, October 15, 2012

DIY: Cobra braid bracelet

You will need, a chain, craft lace (gimp), scissors, pliers, tape, and glue. Wrap the craft lace around your wrist so that it is slightly longer than the circumference of your wrist. Cut the craft lace. Then, using your piece of craft lace measure out another piece that is 8 times the size of the first one. Fold the first piece in half and tape it down on both ends (the folded end and the open end). take the other piece of craft lace and fold that in half as well. take the middle and put it behind the piece that is taped down. Slide it up as close to the folded end as possible. Then, fold one side of the string over top of the taped down string, forming a loop or a "P". Take the string on the other side and pull it over the string making the loop, underneath the taped down string, and through the loop. Repeat this on the other side. Continue this step, alternating in sides. Once you get to about an inch left in the taped down lace, remove the tape. Take the open end and fold it back, creating a loop. Continue knotting, going over all four strands of lace. Tie a knot at the end of the lace and cut off any excess.Take the chain and measure it out so that it is half the length of your wrist. Use the scissors to break the links to separate the piece you want from the rest of your chain. Use the pliers to connect the chin to the loops on either end of the braided lace.

Cobra braid bracelet

Stay Beautiful! ;D

No comments:

Post a Comment