Total Pageviews

Saturday, November 3, 2012

DIY: Fishbone bracelet

You will need chain, one meter of suede cord, beads, and pliers. Wrap the chain around your wrist so that there is a one inch gap between the end and the rest of the chain. use the pliers to break the chain link connecting the section you measured and the rest of the chain. Use the pliers to remove the link. Separate two more pieces of chain, they should be two links shorter than the first piece. Take the suede cord and pull it through the second link in the longest chain so that the same amount of suede cord is on each side of the chain. Then, string a short chain onto each side of the suede cord through the first link. take the suede cord from one of the sides and thread it through the first open link in the longest chain. Then, do the same on the other side, but put the cord in the same link as the first cord. Both cords should be in the same link. Then, thread the cord back into the short chains. Keep repeating these steps until you get to the bottom of the bracelet. Then, take one of the cords and thread it through the loop at the top of the bracelet. Take a bead and thread it on to the cord, then tie a knot at the end to secure it. Do the same to the other cord and your done.

Fishbone bracelet tutorial

Stay Beautiful! ;D

No comments:

Post a Comment